Isolate Fabrication Services in Revit Using Dynamo

In All, Fabrication by David Ronson5 Comments

In CADmep we used the command SL1 to isolate a service. Revit does not have a good isolation command so I wrote one using Dynamo, below is a link to download the script.

Comments

  1. Would like to download the Isolate Fabrication Services in Revit using Dynamo Script, but I don’t see the link.
    Could you point me in the right direction? It is greatly appreciated.

  2. Got them. Thank you. Now it says run complete with errors and does not get to the select service dialog.

Leave a Comment