Revit – Housekeeping pad (Part 1 of 3)

All, Architecture and Engineering, Construction 0 Comments

This question usually comes up in training or support on a regular basis, so I decided to show you a couple of different ways to create a basic housekeeping pad. In MEP, you might have the need to create a pad for your equipment. You can use a couple of different methods to create a pad in Revit. You create an In-place family for a specific single instance. You can also make a simple foundation and offset your equipment after placement. Alternatively, you can make a simple foundation pad family that will flex on an instance basis. In the following video I will go through each option:

Part 1 — Structural Foundation Pad

Leave a Comment